Latest Update 26-06-2017,
IPad Air Charging Problem Jumper Ways
Before proceeding, ensure that the battery and the battery charger are in good working condition. Then the fuse, diode, capacitors and filter coil for possible open or short circuit. Trace each of the connection line paths from USB pins down to the components where it is directly connected.Check all the components shown in the image below, you may start by checking the USB pin connector.
This problem is may cause by a faulty charger or faulty components on iPad Air PCB board. This problem may sometimes happen if the device suffered wet or water damage or just exist.Not Charging problem like there is No Charging indication shows on the display
This problem is may cause by a faulty charger or faulty components on iPad Air PCB board. This problem may sometimes happen if the device suffered wet or water damage or just exist.Not Charging problem like there is No Charging indication shows on the display
Now re-solder charging Connecter pihn and Cheack.
Make sure that the voltage is between 5V to 5.5V, if it is not then replaced charging connector.
All of the above steps will surely help you to resolve your iPad Air charging problems in the best possible manner. If you are lucky enough then simple workaround method will get the job done for you.
Hardware Solution Picture Bellow:
Note: Please note that even though every solution posted on our website is tested by one or more members of our team before posting, but still we do not take any responsibility for any damage it may cause to your cell phones. Use these repairing solutions at your own risk.
0 comments:
Post a Comment