The solution for Apple iPad 2 Not Charging problem like there is No Charging indication shows on the display when the battery charger is being a plug-in.
This problem is may cause by faulty components on iPad 2 PCB board. This problem may sometimes happen if the device suffered wet or water damaged or just exist.
Before proceeding, ensure that the battery and the battery charger are in good working condition.
- Check all the components shown in the image below, you may start by checking the USB pin connector.
- Then the fuse, diode, capacitors and filter coil for possible open or short circuit.
- Trace each of the connection line paths from USB pins down to the components where it is directly connected.
Be sure to check the battery and charger are Exactly working condition. then verify the phone’s USB pin connector is broken or any fault.
Check the charging (+) and (-) line paths are short using a multimeter, if it shows short them, remove/replace the diode, capacitors and filters. also, replace the fuse. Note: use these work at your own risk.Check all the components shown in the image below.
Repair hints for Apple iPad 2 Not Charging Problem:
1. Try to use another working charger.
2. Check, clean or replace the charging pin connector if oxidized.
3. Clean the charging pin connector terminal contact pads.
4. Check/ replace the fuse and the chip diode.
5. Check/replace the highlighted transistor, resistors, and capacitor.
6. If the above procedure won’t fix the problem, the possible faulty Charging IC.
7. Reheat, rework charging ic, replace if necessary.
0 comments:
Post a Comment